Heating EOVP-6, 6 kW, 400 V, plastic with el. flow

Electric flow heaters are designed to heat water in pools and whirlpools, the activity consists of heating water through the heating body, the heated water temperature is set by a control thermostat. The heater is switched by the contactor, which is controlled by the thermostat, the safety indicator of the flow. For this reason, the so -called large automatics - 24 -hour filtration programmer, current protector (protection against dangerous touch voltage), engine thermal protection, contactor and heating switch are required for heating. Pool electrical flow heaters of water type EOV, EOVP, EOVK, EOVTI, ELAVTI and EVAV are specially designed for heating pool water, or water in other water circuits with flow and temperature up to 40 & deg; c. Each heater must be installed behind the current protector in the electrical system. Therefore, we recommend adding the device to the appropriate type of automatic control from VAGNER, which reliably ensures not only the required comfort but also the safety of the operator. The difference between EOV and EOVP is in the use of plastic on the body of the sheath and in the use of a flow flap instead of a pressure switch as a protective element for water flow. Each electric heating of eov: It uses the conversion of el. energy on energy is made of high quality PVC (EOVP type) has a heating patron made of stainless steel Incoloy 800, M1182 that guarantees the best quality is 100% tested for tightness can be connected to the water circuit by gluing 50 mm It is equipped with a thermostat up to 40 & deg; c and a thermal fuse is equipped with a flow switch that controls the water flow is equipped with 2 pieces of holders for easy fastening Operating Conditions: Minimum water flow: 4 m 3 /h Operating pressure: 0-3 bar Connection: To the water circuit with a pipe diameter of 50 mm Water quality: chloride content max. 150 mg/l chlorine content max 1 mg/l PH range 7,0--7,8