Heating EOV-18, 18 kw 400 V, stainless steel, with pressure switch

Electric flow heaters are designed to heat water in pools and whirlpools, the activity consists of heating water through the heating body, the heated water temperature is set by a control thermostat. The heater is switched by the contactor, which is controlled by the aforementioned thermostat and safety indicator of the flow. For this reason, the so -called large automatics - 24 -hour filtration programmer, current protector (protection against dangerous touch voltage), engine thermal protection, contactor and heating switch are required for heating. Pool electrical flow heaters of water type EOV, EOVP, EOVK, EOVTI, ELAVTI and EVAV are specially designed for heating pool water, or water in other water circuits with flow and temperature up to 40 & deg; c. Each heater must be installed behind the current protector in the electrical system. Therefore, we recommend adding the device to the appropriate type of automatic control from VAGNER, which reliably ensures not only the required comfort but also the safety of the operator. The difference between EOV and EOVP is in the use of plastic on the body of the sheath and in the use of a flow flap instead of a pressure switch as a protective element for water flow. & nbsp; Each electric heating of eov: It uses the conversion of el. energy on energy It is made of high quality stainless steel with an admixture of titanium AISI 316 (type EOV) is made of high quality PVC (EOVP type) It has a heating patron made of stainless steel Incoloy 800 with the admixture of titanium that guarantees the best quality is 100% tested for tightness can be connected to the water circuit via the thread of 1.5 & quot;, 50 mm hose or gluing 50 mm It is equipped with a thermostat up to 40 & deg; c and a thermal fuse is equipped with a pressure switch that controls the water flow (type EOV) is equipped with 2 pieces of holders for easy fastening Greater performance up to 36 kW as agreed to order Operating Conditions: Minimum Water Flow: 4 m 3 /h (when the pressure switch is reset from 1,000l /h) Operating pressure: 0-3 bar Connection: To the water circuit with a pipe diameter of 50 mm Water quality: chloride content max. 150 mg/l chlorine content max 1 mg/l PH range 7,0--7,8