Heating - Ente -3, 3 kw, 230 V Titan - for above -ground pools

Electric flow heaters are designed to heat water in pools and whirlpools, the activity consists of heating water through the heating body, the heated water temperature is set by a control thermostat. The heater is switched by the contactor, which is controlled by the thermostat, the safety indicator of the flow. For this reason, the so -called large automatics - 24 -hour filtration programmer, current protector (protection against dangerous touch voltage), engine thermal protection, contactor and heating switch are required for heating. The entire heating device is made of titanium stainless steel (for salt water) or plastic. Pool electrical flow heaters of water type EOV, EOVP, EOVK, EOVTI, ELAVTI and EVAV are specially designed for heating pool water, or water in other water circuits with flow and temperature up to 40 & deg; c. Each heater must be installed behind the current protector in the electrical system. Therefore, we recommend adding the device to the appropriate type of automatic control from VAGNER, which reliably ensures not only the required comfort but also the safety of the operator. & nbsp; Ealti, this flow heater is designed to heat water in above -ground pools. The heater itself is attached to a stainless steel stand that ensures a stable heater position after anchoring. The body of the heater is, as with the type of EOVTI, of plastic resistant to high temperature and the heating patron is made of titanium. The thermostat is used to regulate the temperature up to 40 & deg; c; The heater is equipped with a flexo cord for connection to a 230 V socket after a current protector. Connection to water circuit with hose thorns 38 mm, or thread 1.5 & quot; In. Each heater is tested for tightness. Operating Conditions: Minimum water flow: 4 m 3 /h Operating pressure: 0-3 bar Connection: To the water circuit with a pipe diameter of 50 mm Water quality: chloride content max. 150 mg/l chlorine content max 1 mg/l PH range 7,0--7,8