Heating EOVTI-6, 6 kW, 3 x 230 V, titanium with el. flow

Electric flow heaters are designed to heat water in pools and whirlpools, the activity consists of heating water through the heating body, the heated water temperature is set by a control thermostat. The heater is switched by the contactor, which is controlled by the thermostat, the safety indicator of the flow. For this reason, the so -called large automatics - 24 -hour filtration programmer, current protector (protection against dangerous touch voltage), engine thermal protection, contactor and heating switch are required for heating. The entire heating device is made of titanium stainless steel (for salt water) or plastic. Pool electrical flow heaters of water type EOV, EOVP, EOVK, EOVTI, ELAVTI and EVAV are specially designed for heating pool water, or water in other water circuits with flow and temperature up to 40 & deg; c. Each heater must be installed behind the current protector in the electrical system. Therefore, we recommend adding the device to the appropriate type of automatic control from VAGNER, which reliably ensures not only the required comfort but also the safety of the operator. Electric heating of eovti: It uses the conversion of el. energy on energy is made of high quality PVC fitted with titanium heating patron. Titan preferably from the & nbsp; available materials withstanding corrosion is 100% tested for tightness This type of heating is suitable for abnormal stress and greater concentration of chlorine. It can be used in combination with any water treatment, such as electro-chemical salinators, etc. It is equipped with a thermostat up to 40 & deg; c and a thermal fuse is equipped with a flow switch that controls the water flow is equipped with 2 pieces of holders for easy fastening Operating Conditions: Minimum water flow: 4 m 3 /h Operating pressure: 0-3 bar Connection: To the water circuit with a pipe diameter of 50 mm Water quality: chloride content max. 150 mg/l chlorine content max 1 mg/l PH range 7,0--7,8